Colored lights indicate the status of the machine, blanks supply, and tape or hot melt supply.
Non-Standard Case Dimension
Machine can be modified for a variety of case dimensions. Please contact Lantech for details.
Increases speed to maximum of 30 cases per minute. Please contact Lantech for details
Various communication configurations possible. Please contact Lantech for details.
Stainless Steel Frame or Components
Please contact Lantech for details.
Exit Height Extension
The exit height of the cases can be extended in increments of 50 mm up to a maximum of 850 mm.
Tape Head Storage Bracket
Holds additional tape head.
75mm (3") Tape Head
Applies 750 mm (3") wide tape. Replaces standard 50 mm (2") tape head.
Increases the number of blanks the magazine holds.
Decreases the number of blanks the magazine holds.
Many options available for case types and dimensions, speeds, closing methods, machine frame and magazine, and machine performance data communications are available. Please contact Lantech Customer Support if your requirements are not satisfied by the options published on this page.
An alarm sounds to indicate the presence of a fault condition.
(30 CPM option)
Case Size Minimum
(Outside Dimensions) 200 mm L
150 mm W
150 mm C
(7 7/8" L x 5 7/8" W x 5 7/8" C)
Case Size Maximum
(Outside Dimensions) 500 mm L
325 mm W
520 mm C
(19 5/8" L x 12 3/4" W x 20 1/2" C)
Case Types RSC, HSC, FEFCO 0200/0201
Flute Types B, C, E or Combinations
Wall Types Single & Double Wall (test for multiple wall)Bottom Seal
Tape Lantech TH-Series
Hot Melt Refer to Manufacturer ManualService Requirements
Air Supply 6 Bar (80 Psi)
Dedicated Electric Service Req. US 230V, 3ph, 60Hz, Wye w/Ground
Dedicated Electric Service Req. EU 3L-PE-400V-50Hz-NeutralMachine Data
Magazine infeed Capacity 200 Cases (approximate)
1955 mm L
2280 mm W
1800 mm H
(77" L x 89 3/4" W x 70 7/8" H)
Outfeed Pass Height
600 mm +/- 30 mm
(23 5/8" +/- 1 1/8")
Warranty Duration 3 Years, Unlimited Cycles